User Manual

18
ENGLISH
4.3 Symbols on the machine
A
Danger!
Disregard of the following warnings
could lead to serious personal injury
or material damage.
Read instructions.
Unplug mains cable.
Band saw blade running
direction.
Information on the nameplate:
4.4 Safety devices
Upper blade guard
The upper blade guard (37) protects
against unintentional contact with the
saw blade and from chips flying about.
In order for the upper blade guard to pro-
vide adequate protection against contact
with the band saw blade, it must always
be set as close as possible against the
workpiece (max. distance 3
mm).
Lower blade guard
The lower blade guard (38) protects
against inadvertent contact with the
band saw blade below the saw table.
The lower blade guard must be installed
during operation.
Housing doors
The housing doors (36) protect against
contact with the rotating parts inside the
machine.
The housing doors are equipped with
interlocking contacts. These turn the
motor OFF when one housing door is
opened while the saw is running.
The housing doors must be closed while
the machine is in use.
Push stick
The push stick serves as an extension of
the hand and protects against accidental
contact with the saw blade.
The push stick must always be used if
the distance between band saw blade
and a rip fence is less than 120
mm.
Guide the push stick at an angle of
20 ° … 30 ° against the saw table's surface.
When the push stick is not used, it can
be stored on the push stick holder pro
-
vided at the band saw frame.
Replace the push stick if damaged.
• Set upper blade guide to its lowest
position.
• Remove projecting accessories.
• Transport the saw with the help of a
second person.
• For transport use the original pack-
ing where possible.
3
Note:
In this chapter the essential oper-
ating elements of the machine are intro-
duced.
The proper use of the saw is detailed in
chapter “Operation”. Read this chapter
before using the saw for the first time.
ON/OFF switch
• To start = press green switch button
(39).
• To stop = press red switch button (40) .
In the event of a power failure an under-
voltage relay will trip. This prevents the
starting of the machine when the power
is restored. To restart, the green switch
button must be pressed.
Turn-lock fastener, housing door
Open and close the housing door using
the turn-lock fastener (41).
Opening the housing door:
1. Rotate the upper turn-lock fastener
clockwise approx. one turn and the
lower turn-lock fastener anticlock
-
wise approx. one turn.
The housing door opens slightly.
This activates the door interlock
which switches the motor off.
28 Manufacturer
29 Serial number
30 Machine designation
31 Motor specifications (see
also "Technical Specifications")
32 CE mark – This machine meets
the EC directives as per declara
-
tion of conformity
33 Waste disposal symbol – Device
can be disposed of by returning it
to the manufacturer
34 Date of manufacture
35 Dimensions of approved band saw
blades
29
30
31
32 33 35
28
34
5. Transport
36
37
38
36
6. Machine details
39
40
41