Installation Guide

© Metal Sales Manufacturing Corporation / Subject to change without notice / Effective 6/14
30
CLASSIC RIB
®
RESIDENTIAL PANEL INSTALLATION
INSTALLING FIRST PANEL
INSTALLING INSIDE CLOSURES
INSTALLING
PANEL CLIP
STEP
1
STEP
2
FASTENER
INSIDE CLOSURE
w/ TAPE SEALANT
TAPE SEALANT
INSIDE CLOSURE
ROOF PANEL
1. Apply a row of Tape Sealant across the top leg of the Eave Molding along the width of
the building.
2. Align and place Inside Closures over the Tape Sealant. It is critical that Inside Closures are square
to building as this will control the alignment of the panels. (see page 24 to check building square).
3. Apply a row of Tape Sealant across the top of the Inside Closure (not shown for clarity).
1. Install the rst panel over the Inside Closure to allow for desired overhang. Make sure the panel
is square to the eave and rake.
2. Fasten through panel, closure, and sealants into decking with appropriate amount of fasteners to
meet local building code. (see fastening pattern on page 6). Fasteners must penetrate closure and
sealant.
3. After securing panel at eave, repeat the fastening pattern at the appropriate spacing to meet local
building codes.
NOTE: -Eave Molding, Gutter and Valley Flashings must rst be installed before panel installation can begin.
-Panels can be installed going from either left to right or right to left / looking from eave to peak.
FASTENER