User Guide

6.7 Changing the tool (Fig. 5)
Important! Set the changeover switch to its
centre position whenever you carry out any work
(for example changing the tool, maintenance
work, etc.) on the cordless screwdriver.
·
Insert the bit (a) into the bit chuck (1).
· Check that it is secure by attempting to pull the
tool apart again.
6.8 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating
instructions, to suit the size of screw.
7. C
leaning and maintenance
A
lways pull out the mains power plug before
starting any cleaning work.
7.1 Cleaning
·
Keep all saf
ety devic
es, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
·
We recommend that you clean the device
immediately each time you have nished using it.
·
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8. D
isposal and recycling
T
he unit is supplied in packaging to
prevent its being damaged in transit.
This packaging is raw material and can
therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local
council.
9