User`s guide

8
MS951- 47 and MS961- 47 Scanner Installation to the PC
(Scanner with Built-in PC Keyboard Wedge Interface)
To maintain compliance with applicable standards, all circuits connected to the
scanner must meet the requirements for SELV (Safety Extra Low Voltage)
according to EN 60950.
1. The “Y” coil cable is terminated with a 5-pin DIN female connector
on one end, and a 6-pin mini DIN male on the other. Also included
with the MS951 is an adaptor cable with a 5-pin male DIN on one
end and a 6-pin female mini DIN on the other to mate to a specific
keyboard. According to the termination required, connect the appro-
priate end of the adaptor cable to the coil cable, leaving the neces-
sary termination exposed for connecting to the keyboard and the
keyboard port on the PC. Refer to Appendix C page 40 for pin
assignments.
2. If the PC is on, exit the application and turn the PC off.
3. Disconnect the keyboard from the PC.
4. Plug one end of the coil cable into the keyboard connector on the PC.
Then plug the keyboard connector into the other end of the coil cable.
5. Power up the PC.