User`s guide

Figure 2

Components of the MS900 Series Stand

The following are the components used to build the MS900 series stand

(MLPN: 45482):

1 Cradle 4 Wood Screws

2 Stand Cover 5 Internal Lock Washer

3 Stand Base 6 Flexible Shaft

Installation of the MS900 Series Stand

1. Use the 2½ inch x 2½ inch stand base to mark the position for pilot holes.

2. Use the four wood screws to secure the base to the work surface.

3. Position the stand cover on top of the stand base. Screw the flexible

shaft to the stand base (Refer to Figure 3).

4. Place the internal lock washer on top of the flexible shaft and then

screw the cradle to the shaft (Refer to Figures 4 and 5).

Note: Fasten the stand to the work surface before adjusting the angle of

the flexible shaft. To adjust the angle, firmly hold the shaft and

push the shaft to a north, south, east, or west direction.

Caution: This device can generate an electromagnetic field. Position stand at

least 12 inches from computer monitor, diskettes, or other

magnetically sensitive devices.