User`s guide

Quick Start

1.) Plug in the scanner. When the MS951 is ready to

scan, the red LED will turn on, followed by the

green LED, and then the scanner will emit one

beep.

2.) The scanner is shipped from the factory pro-

grammed with default settings. To configure

the MS951 scanner to meet the host system’s

specific needs, refer to the Programming

Guide (MLPN 2366) for instructions on how

to enter the program mode and to select the

appropriate bar codes.

Note: Keyboard Wedge scanners default to Keyboard Wedge

Communications and USA, AT keyboard when the Recall

Defaults is scanned. With all other versions, the Recalll Defaults

barcode configures the MS951 for an RS-232 interface. If RS-232

is not being used, scan at least one other bar code to enable OCIA,

Light Pen or 46xx.