Operation Manual

98
k
Testing remote flash mode
• Place the slave flash units in the desired positions for
the shot. Use flash unit mounting foot S60 (optional
accessories) to set up the slave flash unit.
• Wait for the flash readiness of all connected flash
units. Once the slave flash units have achieved flash
readiness, the “STATUS” LED

lights up in green.
• Press the manual firing button on the master or
controller flash unit to fire a test flash. The slave flash
units respond with a test flash, if supported by the
camera.
If a slave flash unit does not issue a test flash, correct
the position of the slave flash unit to enable the slave
sensor

to receive the light sent by the master/con-
troller flash unit.
5.5 Video light
Use the video light to illuminate shots of moving images
at close range.
• Press button

briefly.
The flash unit always switches on afterwards with the
mode of operation that was used last.
• Press the “LED” button

on the flash unit to switch
on the video light. Each time you press the “LED”
button

, the light output switches between “full”
and “half”
If the “LED” button

lights up continuously, you have
set the full light output; if it blinks slowly, the light output
is set to half
.
If the batteries are almost empty, the video light
switches off and the “LED” button

blinks quickly.