User Manual

139
k
• The flash unit is exclusively designed and authori-
sed for use in photographic applications.
• Only use the power sources designated and aut-
ho-rised in the operating manual!
• Do not open the batteries or short them!
• In no event the batteries be exposed to high tem-
peratures like direct sunlight, fire or similar!
• Never throw flat/dead batteries onto a fire!
• Do not use any toxic batteries or rechargeable bat-
teries!
• Remove the used batteries immediately from the
device! Chemicals can escape from used batteries
(so-called “leaks”) resulting in damage to the
device!
• Batteries may not be recharged!
• Do not expose the flash unit to water drops and
splashes!
• Protect your flash unit from heat and high air
humidity! Do not keep it in the glove compartment
of your car!
• Rapid changes in temperature may lead to con-
densation. If this occurs, allow time for the unit to
become acclimatized!
• When you activate the flash, there should be no
opaque material directly in front of or on the
reflector cover (flash window). The intense energy
emissions can otherwise lead to scorching or
spotting of the material and/or the reflector cover.
• After a series of flashes with full power and short
intervals, a pause of at least 3 minutes must be
observed after each series of 20 flashes!
• When taking a series of flash shots at full light
output and with rapid recycling times, and with
zoom positions of 35 mm and less, the diffuser
heats up, due to the high level of thermal energy.
• This flash unit may be used in combination with a
camera-integrated flash only if the flash can be
folded out completely.