User Manual

142
k
3.2 Mounting the flash unit
Mounting the flash unit on the camera
Turn off the camera and flash before mounting or
removing.
• Turn the knurled nut  towards the flash unit
housing as far as it will go. The locking pin in the
adapter shoe is now fully retracted into the case.
• Slide the flash unit foot completely into the came-
ra accessory shoe.
• Turn the knurled nut  towards the camera hou-
sing as far as it will go, clamping the flash unit in
place. If the camera does not have a locking hole,
the spring-loaded locking pin retracts into the
adapter case so as not to damage the surface.
Removing the flash unit from the camera
Turn off the camera and flash before mounting or
dismounting.
• Turn the knurled nut  towards the flash unit
housing as far as it will go.
• Remove the flash unit from the camera’s accesso-
ry shoe.
3.3 Switching the flash unit on and off
• Switch on the flash unit with the

button.
The start screen appears.
The flash unit always switches on afterwards with
the mode of operation that was used last.
The

button flashes red in stand-by mode. To
switch off the flash unit, press the

button
until all displays turn off.
If the flash unit will not be used for an extended
period of time, we recommend that you switch off
the flash unit with the  button and remove the
power source (disposable/rechargeable batteries).
3.4 The selection menu (MODE)
• Press the  button and the drop-down
menu will appear.
The  buttons can be used to select the opera-
ting mode.
AUTO, chap. 7.1
E TTL, chap. 7.2
E TTL HSS*, chap. 7.5
M, chap. 7.4
MHSS*, chap. 7.5
LED, chap. 7.6
MASTER, chap. 10.1
SLAVE, chap. 10.2
SERVO, chap. 10.3
F1 / F2, chap. 7.7
*) only after data exchange with a camera
+
+
+
MODE
AUTO
ETTL
ETTL HSS