User Manual

144
k
Setting the automatic unit switch-off
• Switch on the flash unit with the

button.
The start screen appears. The flash unit always
switches on afterwards with the mode of operati-
on that was used last.
• Press the  button and the menu
will appear.
• Use the  buttons to select the menu option
.
• Press the
°  button and open the menu.
• Use the  button to select the menu option
.
• Press the
°  button and confirm the selected
setting.
The

button flashes red in stand-by mode.
OPT.
STANDBY
ON
4 OLED displays on the flash unit
4.1 Flash readiness indication
When the flash capacitor on the flash unit is char-
ged, the

button lights up in green, thus indi-
cating that the flash unit is ready.
This means that flash light can be used for the next
shot. Flash readiness is also transmitted to the
camera and indicated accordingly in the camera's
viewfinder.
If a photograph is taken before flash readiness
appears, then the flash unit will not be triggered. If
the camera has already switched to flash sync
speed, the shot may have the wrong exposure (see
13.1).
4.2 Correct exposure indication
With proper exposure, the OK symbol will light up
on the display for about 3 seconds if the recording
in flash modes and ; see
7.2) and automatic mode were properly
exposed!
If there is no exposure control indication after the
shot, then the photograph was underexposed.
In that case, you must:
- set the next smaller f-stop (e.g. use f-stop 8 inste-
ad of 11), or
- reduce the distance to the subject or to the reflec-
tion surface (e.g. for indirect flashes), or
- set a higher ISO value on the camera.
Note the maximum flash range indicated on the dis-
play of the flash unit (see 5.2).
HSS
ETTLETTL
AUTO
OPT.
ZOOM
STANDBY
AF-BEAM
STANDBY
OFF
ON
OK