Specifications

MEV™ Mini HUMMER HX™ OWNERS MANUAL

If the charger is left connected to AC power supply, a refresh charge will occur after 10 days

if the battery voltage has dropped below a pre-programmed level. If a refresh charge tries to

start, but the AC power is disconnected, the charger will wait 8 days for AC to be restored.

At this point, the charger will go into sleep mode and a DC disconnect will be required to

reset the charger.

The charger can be connected to any three prong 110-240 volt home outlet with an

available minimum 12 amps of current. To avoid the risk of electrical shorting, the battery

charger must be grounded through a properly installed three prong outlet. Do not use a two

prong adapter.

Locate all cords and wires in locations that will not be driven over or present a tripping

hazard.

Note: The cart and charger are equipped with an interlock device; the cart will not start if AC

Power is pressed. The AC power source must be disconnected first at the cart connector

located on the front bumper prior to operation.

 Do not attempt to service the charger. If the charger requires service, take it to an

authorized MEV dealer or an approved technician.

 Do not overload the AC circuit. The input voltage of the charger should be between 110-

240 volt and supply a current at least 12 Amps.

 The AC side of the charger uses a grounded three prong plug. While charging, use a

three prong wall receptacle with a proper ground. Do not attempt to alter the charger

plug in any way.

 Do not use an adapter plug to go from three prongs to a two prong outlet. This will

result in an ungrounded condition and increase the risk of electric shock and/or fire.

 If an extension cord is used, it must also be a three pronged extension cord with 14 AWG

(American Wire Gauge) wires. No longer than 15m (50 feet). The longer the cable used

means the less effective the charge rate will be.

 Inspect and replace the charger if it has been damaged in any way. Inspect the cords and

connectors for cracks and fraying. If cracks or frays are detected, replace immediately.

 Do not use the charger near volatile liquids such as gasoline, paints, thinners, and other

flammables. The charger can ignite flammable materials and vapours.

 Do not cover or block the cooling slots on the charger as it could potentially overheat.

Charger Operation instructions

1. Always connect the charger to a GROUNDED outlet. When using an extension cord, avoid

excessive voltage drops by using a grounded, 3-wire, 14-AWG cord no longer than 15m (50

feet).

2. AVOID connecting Delta-Q charger and another device to a single 15A20A circuit or the

circuit may become overloaded.

WARNING