Installation manual

www.mgeups.com

THE UNINTERRUPTIBLE POWER PROVIDER

34003905EN/AA

140, Avenue Jean Kuntzmann

ZIRST - Montbonnot St Martin

38334 - Saint Ismier Cedex - France

www.mgeups.com

MGE UPS SYSTEMS T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R

Installation manual

Network

Management

Card Minislot

2006 Edition

(66102)

PAGE 1
MGE UPS SYSTEMS T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R 140, Avenue Jean Kuntzmann ZIRST - Montbonnot St Martin 38334 - Saint Ismier Cedex - France www.mgeups.com 34003905EN/AA THE UNINTERRUPTIBLE POWER PROVIDER Installation manual (66102) Network Management Card Minislot 2006 Edition www.mgeups.
PAGE 2
INTRODUCTION OVERVIEW The Network Management Card (66102) is recommended for central UPSs protecting entire networks or for UPS units backing up critical loads.
PAGE 3
INSTALLATION The Network Management Card (66102) can be hot-plugged on all UPSs from MGE UPS SYSTEMS equipped with a Minislot. It is not necessary to shutdown the UPS, disconnect the load or restart the UPS. ◗ Remove the plastic cover of the Minislot. ◗ Note the MAC address of the card before inserting it. ETH ERN ET Setting s/Sens or ASI 100M 10M On = Blink Link = Act UPS data RS232 66102 Your network is not equipped with a BOOTP/DHCP server ◗ Manual configuration is required.
PAGE 4
SENSOR CONNECTION (option) The Environment sensor is a Network Management Card option. It is available from MGE UPS SYSTEMS (cat. no 66846). The sensor remotely monitors the UPS environment by regularly measuring the temperature and humidity, and checking the states of two external contacts. It can also send alarms (e-mail, SNMP trap) tripped by pre-set thresholds. Connection is made via the Service port (Settings/Sensor) on the Network Management Card. The sensor is detected automatically.