Instruction manual

PARAMETERS

When 100 is set in Pr. 52, the monitored values during stop and during operation differ

as indicated below: (When using the operation panel (FR-PA02

-02), LED of Hz flickers

during stop and is lit during operation.)

Note:1. During an error, the output frequency at error occurrence is displayed.

2. During MRS, the values are the same as during a stop.

During offline auto tuning, the tuning status monitor has priority.

Pr. 52

0 100

During operation/

during stop

During stop During operation

Output frequency Output frequency Set frequency Output frequency

Output current Output current

Output voltage Output voltage

Alarm display Alarm display

Note:1. The monitoring of items marked × cannot be selected.

2. By setting "0" in Pr. 52, the monitoring of "output frequency to alarm display"

can be selected in sequence by the key.

3. Running speed on the PU main monitor is selected by "other monitor

selection" of the parameter unit (FR-PU04-MGI).

4. The actual operation time displayed by setting "23" in Pr. 52 is calculated

using the inverter operation time. (Inverter stop time is not included.) Set "0"

in Pr. 171 to clear it.

5. The actual operation time is calculated from 0 to 99990 hours, then cleared,

and recalculated from 0. If the operation time is less than 10 hours there is

no display.

6. The actual operation time is not calculated if the inverter has not operated

for more than 1 hour continuously.

7. When the operation panel is used, the display unit is Hz or A only.

SET

M4500E.book 93 ページ２００５年２月２２日　火曜日　午後５時７分