Instruction manual

47
3
OPERATION/CONTROL
(3) Combined operation mode 1 (Pr. 79 "operation mode selection" = 3)
(4) Combined operation mode 2 (Pr. 79 "operation mode selection" = 4)
The start signal is an external signal.
The frequency setting signal
is set using the optional operation
panel or parameter unit.
• Start signal .......................Switch, relay, etc.
• Operation unit ..................Operation panel (FR-PA02
-02) or
parameter unit (FR-PU04-MGI)
• Connection cable .............Refer to (2) PU operation mode.
• FR-E5P (option)...............Refer to (2) PU operation mode.
The start signal
is entered from the operation command key
of the optional operation panel.
The frequency setting signal
is set using the external
frequency setting signal.
• Frequency setting signal .. 0 to 5V, 0 to 10V or 4 to 20mA
DC signals from an external
potentiometer or from outside
the inverter
• Operation unit ..................Operation panel (FR-PA02
-02)
or parameter unit (FR-PU04-
MGI)
• Connection cable .............Refer to (2) PU operation mode.
• FR-E5P (option) ...............Refer to (2) PU operation mode.
Preparation
Preparation
M4500E.book 47 ページ ２００５年２月２２日 火曜日 午後５時７分