Instruction manual

58
OPERATION/CONTROL
3.3.3 PU operation mode (Operation using the operation panel)
(1) Using the operation panel (FR-PA02-02) for operation at 60Hz with
digital frequency setting
By repeating step 2 below during motor run, speed can be varied.
Operation command: key or key of the operation panel (FR-PA02
-02)
Frequency setting: key
Related parameters:Pr. 79 "operation mode selection".
(2) PU jog operation
Hold down the (or or ) key to perform operation, and release it to stop.
1) Set Pr. 15 "jog frequency" and Pr. 16 "jog acceleration/deceleration time".
2) Select the PU jog operation mode. (Refer to page 53.)
3) Hold down the (or or ) key to perform operation.
(If the motor remains stopped, check Pr. 13 "starting frequency". The motor will not
start if its setting is lower than the starting frequency.
Step Description Image
1
Power on
→ Operation mode check
Switch power on, refer to page 52, and set "1" in Pr. 79
"operation mode selection".
The [PU] indication is lit.
2
Running frequency setting
Set the running frequency to 60Hz.
1) Refer to page 50 and choose the frequency setting mode
using the key.
2) Refer to page 51, change the setting using the key,
and press the key to write the setting.
3
Start
Press the key (or / key). The monitoring mode is
automatically selected and the output frequency is displayed.
The [RUN] indication is lit to indicate forward rotation, or
flickers to indicate reverse rotation.
4
Stop
Press the key.
The motor is decelerated to a stop.
The [RUN] indication goes off.
RUN
/
FWD
REV
/
ON
PU
MODE
/
SET
(or)
MODE SET REV
STOP
RESET
FWD
Hz
A
PU
RUN
MON
EXT
RUN
FWD
REV
RUN
MODE SE T RE V
STOP
RESET
FWD
Hz
A
PU
RUN
MON
EXT
REV
FWD
STOP
RESET
Hz
PU
MON
RUN
FWD
REV
RUN
FWD
REV
M4500E.book 58 ページ ２００５年２月２２日 火曜日 午後５時７分