Instruction manual
Table Of Contents
- SAFETY INSTRUCTIONS
- CONTENTS
- CHAPTER 1 OUTLINE
- CHAPTER 2 INSTALLATION AND WIRING
- CHAPTER 3 OPERATION/CONTROL
- CHAPTER 4 PARAMETERS
- CHAPTER 5 PROTECTIVE FUNCTIONS
- 5.1 Errors (Alarms)
- 5.2 Troubleshooting
- 5.2.1 Motor remains stopped.
- 5.2.2 Motor rotates in opposite direction.
- 5.2.3 Speed greatly differs from the setting.
- 5.2.4 Acceleration/deceleration is not smooth.
- 5.2.5 Motor current is large.
- 5.2.6 Speed does not increase.
- 5.2.7 Speed varies during operation.
- 5.2.8 Operation mode is not changed properly.
- 5.2.9 Operation panel (FR-DU04) display is not provided.
- 5.2.10 POWER lamp is not lit.
- 5.2.11Parameter write cannot be performed
- 5.3 Precautions for Maintenance and Inspection
- CHAPTER 6 SPECIFICATIONS
- CHAPTER 7 OPTIONS
- APPENDICES
- REVISIONS
INSTALLATION AND WIRING
9
(2) Installation of attachment for conduit connection (060, 100)
An attachment for conduit connection is a standard accessory for models M4500-060 and M4500-100. It is
shipped together with the inverter in one crate. If the inverter is not installed inside an electrical enclosure,
mount this attachment according to the below instructions. If the inverter is mounted inside an electrical
enclosure and conduit is not used, it is not necessary to use this attachment.
1) Preparation
confirm that the following parts are enclosed with the indicated quantity.
No. Name Quantity
1 Conduit connection frame 1
2 Cover 1
3 Cover installation screw 4 (M4)
4Cap 3
2) Installation
(a) Fix with the two installation screws (combined tightening) at the bottom of the inverter unit and the two
screws at the bottom of the attachment.
(b) Install caps on the holes through which wires are not passed.
After installing the cap, bend the metal clasps to fix in position.
Inverter unit
1) Conduit connection fram
e
4) Cap
3) Cover installation screw
2) Cover
Note: To extend the heat-sink of 060 and 100 models through the back of an enclosure, an adapter model
no. FR-A5CN06 must be used, and it is not possible to use the conduit connection attachment.