Instruction manual
Table Of Contents
- SAFETY INSTRUCTIONS
- CONTENTS
- CHAPTER 1 OUTLINE
- CHAPTER 2 INSTALLATION AND WIRING
- CHAPTER 3 OPERATION/CONTROL
- CHAPTER 4 PARAMETERS
- CHAPTER 5 PROTECTIVE FUNCTIONS
- 5.1 Errors (Alarms)
- 5.2 Troubleshooting
- 5.2.1 Motor remains stopped.
- 5.2.2 Motor rotates in opposite direction.
- 5.2.3 Speed greatly differs from the setting.
- 5.2.4 Acceleration/deceleration is not smooth.
- 5.2.5 Motor current is large.
- 5.2.6 Speed does not increase.
- 5.2.7 Speed varies during operation.
- 5.2.8 Operation mode is not changed properly.
- 5.2.9 Operation panel (FR-DU04) display is not provided.
- 5.2.10 POWER lamp is not lit.
- 5.2.11Parameter write cannot be performed
- 5.3 Precautions for Maintenance and Inspection
- CHAPTER 6 SPECIFICATIONS
- CHAPTER 7 OPTIONS
- APPENDICES
- REVISIONS
4
CHAPTER 4
PARAMETERS
This chapter explains the "parameters" of this product.
With the factory settings, the inverter is designed to perform
simple variable-speed operation. Set necessary parameter
values according to the load and operating specifications.
Always read the instructions before using the equipment.
4.1 Parameter List .........................................................48
4.2 Parameter Function Details......................................56
Note: By making parameter settings, you can change the functions of contact input
terminals RL, RM, RH, RT, AU, JOG, CS and open collector output terminals
RUN, SU, IPF, OL, FU. Therefore, signal names corresponding to the functions
are used in the description of this chapter (except in the wiring examples). Note
that they are not terminal names.
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7