Operating instructions



BBV, SBV Series Natural Vent Gas Fireplaces
VENTING INSTALLATION
INSTALLATION PLANNING
“B” VENT PIPE
ee ventin installation instructions provided by te 
ent manuacturer
NOTE: is I   ID usin
 vent type pipe tat as been listed by a nationally rec
onied testin aency
eer to ent ipe iin cart or proper elbo oset
runs
imney centerline dimensions are reerenced on ages
  , igures   
 inimum vertical cimney eit   as measured
rom top o unit to top o termination
 aimum vertical eit   as measured rom
top o unit to top o termination
 inimum cimney eit it to   elbos
 
 lbo reuirements llo a maimum o to 
 elbos or our   elbos per installation
NOTE: Two (2) 45° elbows = one (1) 90° elbow
 oriontal run must never eceed  o te eit
o te vent system oriontal runs are measured
center pipe to center pipe
 oriontal runs must ave a minimum  rise per
oot and may not run level or don ill
Attaching 4” Flue to BBV:
 e irst section o vent lue sould overlap
te appliance collar e appliance collar may be
crimped to ease te installation o te irst section
o lue
 Do not penetrate te pipe inner liner it seet met
al scres ttac te initial lue section to te top
o te irebo cassis it  seltappin scres
and plumbers strap ttac te strap toard te
bottom o te lue section and pull taut or proper
tension to te irebo
Attaching 6” Flue to SBV:
 e  appliance collar is slitly larer tat te in
ner all o most vent  pipe sections Install te
irst section o vent by slippin te lues inner
all tot e inside o te appliance collar e vent
outer all ill slip to te outside o te appliance
collar
 Do not penetrate te pipe inner line it seet met
al scres ttac te initial lue section tot e top
o te irebo cassis it  seltappin scres
and plumbers strap ttac te strap toard te
bottom o te lue section and pull taut or proper
tension to te irebo
Support the Pipe
 upport oriontal runs a minimum o every ive 
eet eer to vent manuacturers instructions or
proper support on vertical runs  or less
 upport osets so te eit o te pipe is not bear
in don on te elbos
WARNING
Read all instructions completely and thoroughly before attempting installation.
Failure to do so could result in serious injury, property damage or loss of life.
Operation of improperly installed and maintained venting system could result in
serious injury, property damage or loss of life.
NOTICE
Failure to follow these in-
structions will void the war-
ranty.
INSTALLATION PRECAUTIONS
onsult local buildin codes beore beinnin te instal
lation e installer must make sure to select te proper
vent system or installation eore installin vent kit te
installer must read tis ireplace manual and vent kit in
structions
nly a ualiied installerservice person sould install
ventin system e installer must ollo tese saety
rules
 ear loves and saety lasses or protection
 se etreme caution en usin ladders or en
on rootops
 e aare o electrical irin locations in alls and
ceilins
e olloin actions ill void te arranty on your vent
in system
 Installation o any damaed ventin component
 nautoried modiication o te ventin system
 Installation o any component part not manuac
tured or approved by 
 Installation oter tan permitted by tese instruc
tions
B-Vent Pipe Sizing
  
  