Operating instructions
BBV, SBV Series Natural Vent Gas Fireplaces
CHECK GAS PRESSURE & ELECTRICAL INSTALLATION - MILLIVOLT
eck as type e as supply must be te same as
stated on te appliances ratin decal I te as sup
ply is dierent rom te ireplace STOP! Do not install
te appliance ontact your dealer immediately
o ease installation a mm le line it
manual suto valve as been provided it tis ap
pliance Install and attac as line onto suto
valve
ter completin as line connection pure air rom
as line and test all as oints rom te as meter to
te ireplace or leaks se a solution o ater
and soap or a as snier
o adust lame eit turn I knob to I to et
maimum pressure to burner urn I knob to
to et minimum pressure
o ceck as pressures at valve turn captured scre
counterclockise or turns and ten place tubin
to pressure aue over test point urn unit to i
igure . ter takin pressure readin be sure and
turn captured scre clockise irmly to reseal Do not
over torue eck test points or as leaks
WARNING
Do not use open flame to check for gas
leaks.
&0
-ILLIVOLTGASVALVE
ressure
est I
ressure
est
I nob
ilot dustment cre
Figure 17 -
Gas Pressure Check at Gas Valve
Electrical connections should only be per-
formed by a qualified, licensed electrician.
Main power must be off when connecting to
main electrical power supply or performing
service. All wiring shall be in compliance
with all local, city and state codes. The ap-
pliance, when installed, just be electrically
grounded in accordance with local codes,
or in the absence of local codes, with the
National Electrical Code ANSI/NFPA 70 (lat-
est edition) and Canadian Electrical Code,
CSA C22.1.
CAUTION
Label all wires before disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
ELECTRICAL WIRING
WARNING
eriy proper operation ater servicin