Operating instructions



BBV, SBV Series Natural Vent Gas Fireplaces
LIGHTING PILOT FOR THE FIRST TIME
LIGHTING PILOT
WARNING
The control has an interlock device that does not allow the lighting of the fireplace up to
the moment the safety device of the flame has not interrupted the gas flow. After that pe-
riod of time (when the magnet is closed), it is possible to start the lighting operation.
The gas control knob is designed to be operated by hand. DO NOT use any tools during
this operation. Damaged knobs may result in serious injury.
APPROVED LEAK TESTING METHOD
ou may ceck or as leaks it te olloin metods only
 oap and ater solution
 n approved leak testin spray
 lectronic snier
WARNING
If using a soap and water solu-
tion to test for leaks, DO NOT
spray solution onto control
body.
DANGER
Never check for gas leaks with open
flame!
NOTE: Remove any excessive
pipe compound from the connec-
tions. Excessive pipe compound
can set off electronic sniffers.
eck or as leaks in eac o te olloin locations
ipe rom te as supply line connection to te as valve
 urner connections  ield made oints  as suto valve
 ilot  actory made oints
 ac oint or connection  ll oints on valve and control body
 Depress and turn knob counterclockise
to pilot
position
 Depress ully and old pilot as knob e electronic i
nitor ill automatically inite te pilot eep knob ully
depressed or a e seconds elease and ceck tat
pilot continues to burn
I te pilot does not stay lit repeat teps  and 
TOLIP
O
F
F
P
I
L
O
T
O
N
&0
CONTROLKNOBPILOT
Figure 20 -
Pilot Position
OPERATING INSTRUCTIONS - MILLIVOLT