Operating instructions



BBV, SBV Series Natural Vent Gas Fireplaces
SIGNATURE COMMAND - CHECK GAS PRESSURE and ELECTRICAL INSTALLATION
Figure 25 -
Signature Command Valve
FP1909a
signature command valve
alternate view
8/08
ressure Inlet
ilot dust
ment cre
ressure utlet
 eck as type e as supply must be te same as
stated on te appliances ratin decal I te as supply
is dierent rom te ireplace STOP! Do not install te
appliance ontact your dealer immediately
 o ease installation a   mm le line it manual
suto valve as been provided it on tis appliance
Install and attac  as line onto suto valve
 ter completin as line connection pure air rom
as line and test all as oints rom te as meter to te
ireplace or leaks se a solution o  ater and
soap solution or a as snier
 o ceck as pressures at valve turn captured scre
counter clockise  or  turns and ten place tubin
to pressure aue over test point urn unit to i
igure . ter takin pressure readin be sure and
turn captured scre clockise irmly to reseal Do not
over torue eck test points or as leaks
Do not use open flame to check for gas
leaks.
ELECTRICAL WIRING
General
 is ireplace is euipped it te inature ontrol
valve ic operates on  volts e  volt D adapter
plus into te ireplace unction bo  poer supply
our   batteries are used or back up durin
poer outaes
 e inature ommand ystem can also be operated
itout  poer e system can run on our  
batteries or approimately si  monts under normal
use
Optional Accessory Requirements
 is ireplace may be used it a all sitc andor
inature ommand ireless controls
 e command center control may be mounted on te
all it te use o te  t all mount eten
sion kit
WARNING
Electrical connections should only
be performed by a qualified, licensed
electrician. Main power must be off when
connecting to main electrical power supply
or performing service. All wiring shall be
in compliance with all local, city and state
codes. The appliance, when installed, must
be electrically grounded in accordance with
local codes or in the absence of local codes,
with the National Electrical Code ANSI/NFPA
70 (latest edition) and Canadian Electrical
Code, CSA C22.1.
CAUTION
Label all wires before disconnecting when
servicing controls. Wiring errors can cause
improper and dangerous operation.
WARNING