Operating instructions



BBV, SBV Series Natural Vent Gas Fireplaces
FINAL INSTALLATION
ROCK WOOL PLACEMENT
 lace rock ool on burner to provide loin
embers or best results pull te rock ool
apart into pieces te sie o a nickel or dime
 Distribute one layer o rock ool to cover te
entire burner igure 
 lace te los on te burner eer to o lace
ment ection
I te lame is blue and only in te center turn o unit
and allo to cool ter unit cools remove los I te
back oles are clear add more rock ool to te cen
ter o te burner eplace los and ceck lame aain
ave let over rock ool to reres en cleanin later
oo muc rock ool can disturb te lame and cause
sootin on te lass or los
&0
ROCKWOOL

over it
ock ool
urner

Figure 29 -
Place Rock Wool on Burner
WARNING
Do not use the entire bag of rock wool
to cover the burner. This could cause
the flame to burn poorly and may lead
to sooting.
LOG PLACEMENT
igure 
 lace rear lo  on rate assembly o sould rest
irmly on te to lo mountin pins on te oriontal
bars
 lace bottom let lo  on rate est te back side
o te lo in te lat area o te rear lo
 lace bottom rit lo  on rate est te back
side o te lo in te lat area o te rear lo
 lace te top lo  on te rear lo est te orked
end o te top let lo into te ork o te rear lo est
te narro end o te top on te vertical rate bar
LAVA ROCK AND EMBER PLACEMENT
prinkle lava rock on te loor o te inner combustion
camber venly distribute te rock Do not pile te lava
rock up in ront o rate Do not place lava rock on te
burner I desired purcase optional embers to decorate
te loor o te ireplace
,'
""V3"6LOGPLACEMENT

op o

it o

lat
reas
ear
o 
it ertical
rate ar
enter ertical
rate ar
et ertical
rate ar
o
ountin
ins
et o


Figure 30 -
Log Placement
WARNING
Do not sprinkle the lava rock or ember
chunks on top of the burner. This may
cause potential sooting, glass breakage
and a fire hazard.