Operating instructions



BBV, SBV Series Natural Vent Gas Fireplaces
TROUBLESHOOTING
STANDING PILOT IGNITION
SYMPTOM
 park initer
ill not lit pi
lot ater repeat
ed trierin o
pieo
 ilot ill not
stay lit ater
careully ol
loin litin
instructions
 ilot burnin
valve knob
tuned to 
sitc is turned
to  or 
but burner ill
not inite
 reuent pilot
outae prob
lem
 e pilot and
main burner
etinuis ile
in operation
POSSIBLE CAUSE
 ire disonnected
 Deective initer
 o as or lo as
pressure
D o ropane in
tank
 Deective termocou
ple
 Deective valve
 Deective sitc all
sitc remote control
or ire
 ilot lame too small
 Deective or malunc
tionin termopile
D Deective valve
 ilot lame may be too
i or too lo caus
in pilot saety to drop
out
 Inner vent pipe leakin
eaust ases back
into system
 oriontal vent improp
erly pitced
 Improper vent cap
installation
ACTION
 pen door and ceck to make sure ire is connected to
initer
 eck or spark at electrode and pilot I no spark and elec
trode ire is properly connected replace pilot assembly
 eck remotemanual suto valve rom ireplace o
pressure can be caused by bent lines restricted lines lo
pressure line pressure onsult it plumber or as supplier
D eck ropane tank eill tank
 eck tat termocouple lame impines on termocouple
lean andor adust pilot or maimum lame impinement
nsure tat te termocouple connection at te as valve is
ully inserted and tit
Disconnect te termocouple rom te valve place one mil
livolt lead ire on te tip o te termocouple and te oter
meter lead ire on te termocouple copper lead tart te
pilot and old te valve knob in I te millivolt readin is less
tan m  replace pilot assembly
 I termocouple is producin more tan m  replace aulty
valve
 eck sitc and ire or proper connection lace umper
ires across terminals o sitc I burner comes on replace
deective sitc I te sitc is  repeat te same proce
dure on remote control I burner comes on replace remote
control lace umper ire across ire at as valves termi
nals marked  and  I burner comes on ires are
aulty or connections are bad eplace ire
 I pilot lame is not close enou to te termopile adust
pilot lame
 eck termopile ire connections to make sure all are tit
and tat te termopile is ully inserted into pilot assembly
eck termopile it a millivolt meter onnect leads to 
and  terminals on te control valve I meter readin is
belo m  replace pilot assembly
D urn valve knob to  and sitc to  ake a readin
at te termopile leads    on te valve I te me
ter reads reater tan m  and te burner does not lit
replace deective valve
 lean and adust te pilot lame or maimum lame impine
ment on termocouple
 eck or lue product leak eplace deective pipe section
 eck oriontalvent pipin is runnin upard  per oot
Do not run te pipe level or donard
 eck or proper installation and reedom rom debris or
blockae