MICRONIX PC/104 POWER SUPPLY PV-1075 & PV-1075-CAR NiMH battery pack with charger for PV-5127 User Manual & Installation Guide VERS. 1.3 DOC: M5247DM.REV1.3 Micro Technic A-S • Denmark • Tel. +45 6615 3000 • Fax +45 6615 3077 E-mail: support@micro-technic.com Website: www.micro-technic.
Users Manual & Installation Guide PV- 1075: NIMH BATTERY PACK WITH CHARGER Table of contents TABLE OF CONTENTS ................................................................................................................................................. 2 GENERAL INFORMATION.......................................................................................................................................... 4 ORDERING CODES ............................................................................
Users Manual & Installation Guide PV- 1075: NIMH BATTERY PACK WITH CHARGER Revision history Revision number 1.0 1.1 1.2 1.
Users Manual & Installation Guide PV- 1075: NIMH BATTERY PACK WITH CHARGER General information Ordering codes PV-1075-S S=Stack-through PC/104 connector Available models: Model PV-1075-S PV-1075-S-CAR Ordering code Description 016.104.005 NiMH battery pack with charger. 016.104.093 NiMH battery pack with charger for mobile applications. Accessories This accessories must be ordered separately if needed. Model no PV-1075-NH12 Page 4 of 9 Ordering code 155.104.
Users Manual & Installation Guide PV- 1075: NIMH BATTERY PACK WITH CHARGER Description Micronix PV-1075 is a back-up module with Nickel-Metal-Hydride batteries and integrated charger. PV-1075 is designed to support the Micronix PV-5127, a high power PC/104 UPS power supply. Micronix PV-1075 is a high capacity battery pack for your PC/104 system. An integrated timer controls the charging modes: standard charge and trickle charge. This timer also has the purpose to avoid overcharging.
Users Manual & Installation Guide PV- 1075: NIMH BATTERY PACK WITH CHARGER Connectors The PV-1075 is equipped with four connectors: Input connector (KL2) Power into PV-1075 is supplied through KL2 that is a two-pole removable screw clamp connector. The layout of this connector is shown on the connection drawing above. The voltage used must be in the interval of 18-36V DC (PV-1075-CAR: 10.8V – 13.2V).
Users Manual & Installation Guide PV- 1075: NIMH BATTERY PACK WITH CHARGER Battery connector (J1) The NiMH battery is connected to PV-1075 using J1 that is a two-pole MOLEX connector. The battery connector is disconnected at delivery to prevent deep discharge of the battery when not used for a longer period. PC/104 connector (CN1) PV-1075 is attached the PC/104 stack using CN1. There are no electrical connection to this connector and serves only to bypass the PC/104-bus in the stack.
Users Manual & Installation Guide PV- 1075: NIMH BATTERY PACK WITH CHARGER Technical data Mains input: Input voltage: Input current: PV-1075 PV-1075-CAR PV-1075 PV-1075-CAR Battery charger: Charging modes: Charging time: Charge counter: Battery: Battery voltage: Battery type: Number of cells: Battery capacity: Recommended discharge current(max): Battery protection: Environmental: Temperature range by Standard charge: Temperature range by discharge: Storage temperature: Humidity: Cyclic humidity: Vibrati
Users Manual & Installation Guide PV- 1075: NIMH BATTERY PACK WITH CHARGER Mechanical layout The schematic on this page shows the dimensions for PV-1075. All dimensions are in mm.
