User manual

The inbuilt humidistat is located in the cover of the device. It reads the humidiy of the incoming air, and depending on the set value,
switches on the compressor. In indoor swimming pool halls, the correct air humidity should range between 55% and 65 %.
Decreasing the level of humidity under the above mentioned range is not desirable, considerating the physiological aspects as well
as the aspects of providing building protection. Moreover, it increases the consumption of electrical energy. The humidistat can be
controlled by the user.
Hygrostat display (front view)
3.
3.1.
INSTRUCTIONS FOR USE
Humidity regulation with an inbuilt digital humidistat located in the cover of the equipment
EN
Application mode change
Setting programming functions
Failure reporting
When pressing the button, the set humidity starts to blink.
When you wish to change the set value, press the
When pressing the button again, symbol is displayed, the set value
is memorized and you can read the value of the measured humidity on the display.
button.
When the button is pressed for a longer time than 5 seconds, the following
commands are set: humidity deviation = hysteresis → chosen type =
function of dehumidification or humidification → displayed humidity correction
When pressing the button, the values of each mode you wish to change
are set, and by pressing the button, the following mode is displayed.
DIF ( ) TYP (
COR ( ).
Memory failure. Switch off and then switch on again the electrical connection.
If the failure reporting continues, please ask us to change the component.
Sensor failure. The electrical connection of the sensor is broken off.
Please control the cable.
Sensor failure. The sensor is short-circuited. Please control the cable.
Er1
0-E
S-E
Under the inside cover of the unit, there is a two-positional fan mode switch. In the first position, the fan runs even if the compressor
of the appliance has stopped: continuous operation of the fan. In the second position, the fan only runs simultaneously with the
compressor: periodical duty of the fan. The continuous operation mode of the fan is preferable, since the humidity reader built in the
device continuously reads humidity, and therefore a greater accuracy is reached. At the same time, continuous operation of the fan
results in better air circulation in the room. The installation work supplier selects the mode of the fan according to the request of the
user.
3.3. Fan regulation
3.2. Humidity regulation with a back-up mechanical humidistat located in the electronic box
In the electronic box there is a back-up mechanical humidistat, which is set on the value of 70 % RH. This humidistat has a back-up
function in case of digital humidistat failure. User should not perform any regulation of this humidistat.
Switch of fan operation
Continuous duty of the fan
Periodical duty of the fan
EN - WALL-MOUNTED SWIMMING POOL DEHUMIDIFIER - OWNER´S & INSTALLATION MANUAL