Troubleshooting guide

ENGLISH
7
Setting Reverse Frequency Function
This function is possible only when you are linked to a repeater:
it permits to invert the TX frequency with the RX frequency.
In Channel/Frequency mode, hold down
for two seconds
until “R” appears on the display. Repeat the same procedure
to return to the previous frequency setting.
Scanning
The Scan version is very useful to monitor the channels before
transmitting.
1. Scan all the channels
In Channel/Frequency status, press
, , and
, : the radio will scan from the channel in use
through all the channels. Whenever any activity is detected,
the radio will suspend the scan for 5 seconds. It will then
continue to scan unless you press PTT or
key to end
scanning.
2. Priority channel scan
In Frequency Mode, press
, , and
. The radio will scan from the current frequency through
all the frequency range within 1MHz. Whenever any activity
is detected, the radio will suspend the scan for 5 seconds. It
will then continue to scan unless you press the PTT or
key to end scanning.
Select scan type
In Frequency mode, press and rotate the Encoder until the
display shows “SCAN 13”. Press
and turn the Encoder
knob again to select the scan type (TO/CO/SE). Confirm your
selection with
and exit by pressing twice.
TO: Time-operated scan
Even though the radio stops on a busy channel, it will continue
scanning the other channels.
CO: Carrier-operated scan
The radio stops on a busy channel until there is no activity, and
then radio begins scanning the other channels.
SE: Search scan
The radio stops on a busy channel and exits the Scan mode.