Specification Sheet

ManualsBrandsMiele ManualsDeep FryersCS 1411 F

Product and Cut-out Dimensions Page 1 of 4

CS 1411 F Electric Boiler & Fryer CombiSet

1411

Electric

Boiler

Fryer

CombiSet

Location Codes

1 – Spring clips

2 – Appliance front

3 – Installation height

4 – Power supply box with connection cable, Length = 47 ¼” (1200 mm)

240 V 60 Hz 15 A fuse rating

240

fuse

rating

Ensure that the power outlet is accessible after installation

5 – Drain valve – Ensure that the underside of the appliance is always accessible for draining away the water.

6 – Rating label – Ensure that the electrical supply matches the rating. Adhere rating label sticker supplied with the

appliance into the manual.

Shipping weight 23 lbs (10.4 kg)

Shipping dimensions 26” (660 mm) L x 16” (406 mm) W x 16” (406 mm) H

Notes

Indoor use

Deep fat fryers must not be installed directly next to a gas combiset. A minimum distance of 11 5/16” is required.

The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of

the appliance provides a sufficient seal for the countertop.

All installations must be done in accordance with local codes.

Drawing is not to scale Specification Sheets OJS

02212012

Summary of content (4 pages)

PAGE 1
Product and Cut-out Dimensions Page 1 of 4 CS 1411 F Electric Boiler & Fryer CombiSet Location Codes 1 – Spring clips 2 – Appliance front 3 – Installation height 4 – Power supply box with connection cable, Length = 47 ¼” (1200 mm) 240 V V, 60 Hz Hz, 15 A fuse rating Ensure that the power outlet is accessible after installation 5 – Drain valve – Ensure that the underside of the appliance is always accessible for draining away the water.
PAGE 2
Product and Cut-out Dimensions Page 2 of 4 CS 1411 F Electric Boiler & Fryer CombiSet Cut-out Dimensions For two CombiSet Appliances Cut-out Dimensions For three CombiSet Appliances For the installation of two appliances the width of the countertop cut-out D is the sum of A and C. For the installation of three appliances the width of the countertop cut-out D is the sum of A and B and C.
PAGE 3
Product and Cut-out Dimensions Page 3 of 4 CS 1411 F Electric Boiler & Fryer CombiSet The illustration above represents the attachment of spring clips 1 and support bars 2 for 3 appliances An additional support bar is required for each additional appliance. The position for the attachment of an additional support bar depends on the width of appliance B.
PAGE 4
Product and Cut-out Dimensions Page 4 of 4 CS 1411 F Electric Boiler & Fryer CombiSet Safety distances to back wall 1 – Wall frame 2 – Wall covering x = thickness of the wall covering 3 – Countertop p cut-out 4 – Countertop 5 – Minimum safety distance with flammable materials 2" (50 mm) with non-flammable materials 2" (50 mm) minus x If a wall covering is installed, a minimum safety distance must be maintained between the countertop cut-out and the covering, since high temperatures can damage these materi