operating instructions

D Start the program
The Start button will flash as soon as a
program can be started.
^
Press the Start button.
The Start button will now light up.
–
Prog. running will appear in the
display, followed by Drying and the
program duration.
–
With sensor drying programs, e.g.
Machine iron ... Hand iron etc., the
drying level reached will be shown in
the display later on.
Once drying is in progress, you can
press one of the direct select buttons:
– Button
E Timer to call up the
estimated end time of the program
and the current time of day.
– Button
F Save to save the current
program as a favorite.
– Button
G Cancel to cancel the
current program.
This only applies to machines with a
payment system, if a program can be
cancelled without the loss of credit
.
See section "Changing the program
sequence" for further information about
the following:
–
Payment system
–
Changing a program once it has
started
–
Cancelling the current program
–
Adding or removing laundry after a
program has started
–
Interruption to the power supply
–
Time remaining
program duration/Estimated time
remaining
When a program is selected, the
estimated duration will appear in the
display. Please be aware that it is only
an estimate!
The following factors all affect the
estimated time remaining: residual
moisture content after spinning; type of
fabric; size of load; room temperature;
fluctuations in power supply.
The electronics assess conditions in the
dryer and adjust the estimated time
remaining for a more accurate reading.
Because of this, the time displayed can
alter during the course of a program.
Before the end of a program
In many programs the heating phase is
followed by the cooling down phase:
Cooling down will appear in the display.
The program is not finished until the
cooling down phase has been
completed.
Do not switch the tumble dryer off
before the end of the drying
program.
Short instructions
15