operating instructions

With the help of the following notes minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous.
Check and fault messages in the display
Problem Possible cause Remedy
1
Adjust the load
The drum is empty or
the laundry is too dry.
This is not a fault.
In some programs, if the
drum has been
overloaded or
underloaded, the
program will be
cancelled. This can also
happen if the items are
already dry.
Use the Hot air program
(timed drying) to dry
individual items.
To delete the message:
– Open the door.
;
Technical fault
If restart is unsuccessful,
call Service.
A fault number (e.g.
F43) might also be
displayed.
A program cannot be
started while there is a
fault message in the
display.
– Make a note of what
is shown in the
display.
–
Try to start the
program again.
:
Power failure
program stopped
Press OK button
The dryer was switched
off during a program or
there has been a power
outage.
–
Press the OK button
after switching the
dryer back on and
start the program
again.
Frequently asked questions
28