operating instructions

Problem Possible cause Remedy
E
Clean out airways
Clean the filters
Check ducting.
appears at the end
of a program.*
There is a blockage
in the ducting system.
–
Confirm with OK.
–
Clean the lint filters.
–
Check all possible causes
given under "The drying
process goes on too long or
even switches off."
E
Clean out airways
Clean the filters
Check ducting.
appears after a
program has been
cancelled.
There is a very severe
blockage in the
ducting system.
–
See above.
\
Maintenance
message
Clean the condenser
unit.
appears after a
while.*
Reminder to clean the
condenser unit (heat
exchanger).
–
Clean the condenser unit.
To delete the message:
– Confirm with OK.
2
Drain fault
Check the drainage
system.
The drain hose is
kinked.
– Remove the kink.
To delete the fault message:
– Confirm with OK.
* You can adjust the setting which controls if or when the check message
appears:
See "Clean condenser unit" and "Clean out airways" in the "Settings/Superviser
level menu" section of the separate booklet "Commissioning, Program chart and
Settings".
Frequently asked questions
29