User's Manual

Chapter One - 2

Gettin

Quick Operation

 Loosen the battery screw, remove the battery insulation sheet, and

mount the battery.

 Connect the AC adapter with the computer and start charging the

battery for at least 10 minutes.

 Turn ON the computer by pressing the power switch.

Notice:

 When ambient temperature is under +5℃ (This is the default setting

for this computer.), the system may not boot up immediately. System

will beep with LED heater light flashing to remind the user while

heater working. Also, the frequency of the LED will become faster to

remind the user while the temperature is approaching to be suitable.

After 5~15 minutes, the system will boot up automatically.

 Under an emergency situation, it is able to skip heating for booting up

the system immediately by pressing the power switch for >9 seconds.

The speaker will also beep with a special sound. (It is not guaranteed

all devices on the computer are possible to work properly.)

 Press the power switch again during the heating process will shut

down the computer.

 Driver or application installation may be necessary for further

operation.

 The following procedures will help to Turn OFF the computer:

1. Press power switch to “Shut Down”, “Standby”* or “Hibernate”*

dependent on operating system (OS) and power management

settings.

2. Press power switch for 4 seconds for a “Hard” power off. But the

system will shut down immediately without saving any data or

parameters.

3. Click Start → Shut Down in Windows to Turn OFF.

Note: Some operating systems may not support the above-mentione

functions.