User's Manual

Chapter Two - 13
O
p
eratin
g
computer malfunction.
The following procedure assumes that all the necessary ODD utilities
were installed on the computer. For ODD utility installation, please refer to
“Utilities and Drivers”. ODD also can be removed and swapped with the
2
nd
battery or 2
nd
SATA HDD.
Put disk into the ODD
While the power is ON, push the ejecting button of ODD. The tray will
release. Then gently pull the tray out. Put the disk with its label facing up
on the holder and push the tray back into the cabinet. Any dirt on the data
side of the disk may cause to the erroneous read. Please avoid touching
the data side.
Read from the ODD
The ODD may be designated as drive D: or higher depending on your
configuration. You may access to it in DOS or Windows. Please avoid
shock or vibration when the optical device is active.
Express and PCMCIA Cards
The computer supports one PCMCIA II and one Express card or two
PCMCIA II cards. To remove the card, push the button on the right of the
card to eject it. The ejecting button can hide into the compartment by
pushing it inward gently.
RTC
Battery backed up RTC (Real Time Clock/Calendar) is built in an on-board
CMOS (Complementary Metal Oxide Semiconductor) chip. The RTC
keeps track of the time and date while the computer is off. The CMOS chip
also stores system setup information.