Compatibility Chart

ManualsBrandsMilescraft ManualsTools & HardwareSign Pro Sign-Making Jig Set for Routers

7 IN. TURNLOCK

ROUTER BASE PLATE MOUNTING KEY

#30081

5 Porter Cable PC7310 (Laminate Trimmer) 1 Skil 1810-01, 1815-04, 1820-04, 1823, 1825-04,

1840, 1845-02

7 DeWalt DW621 1 Craftsman (315.) 175020, 175040, 175050, 175070, 17574

(09) 17511, 17515, 17528, 17533, 26834

(09) 17540, 17541, 17542, 17517

1 Porter Cable PC690, PC7529, PC8529, PC890, PC893PK 8 Ryobi

RE180PL*

1 DeWalt DW618, DW610

1 Black&Decker RP400 9 Bosch PO600

1 Milwaukee 5615-29, 5615-21, 5616, 5619 9 Dremel 963-01 («Advantage» Plunge

Base)

1 Bosch 1604, 1618

1 Hitachi M12VC 10 Festool 900, 1000, 1010

1 Freud FT1700

1 Rigid 2900 Series 11 Hitachi M12V

2 DeWalt DW616 12 DeWalt DW625

2 Craftsman Pro 26835 12 Fein FT-1800

2 Makita 3606 12 ELU 177

2 Freud FT2000E

2 Triton TRC001 13 Bosch 1613EVS

3 Craftsman 27500 14 Bosch 1617

4 Craftsman (315.)275.000 15 Ryobi RE600

This is not intended to demonstrate all possible routers that can be

used with the Milescraft base plate.

Other routers not listed may fit using varied combinations of holes and slots.

• In some instances shown above, NOT ALL holes in a router’s base will match the mounting pattern.

• Only 2 holes matched to a router’s base are required (as a minimum) for proper installation and operation.

• You may decide to modify an existing hole or slot or add a hole(s) to better suit your router.

• The screws supplied may not fit your router. If you supply your own screws, DO NOT use “counter sink head” styles.

• *Ryobi model RE180PL uses 2 special screws that are not provided. Contact customer service at info@milescraft.com

or 224-227-6930 x22 to receive them at no charge. Please include your mailing information in your request.

• Check our website at www.milescraft.com for possible revisions to this mounting key or other information.

• 7 in. Base Plate is included in most Milescraft

TurnLock™ router products.

(e.g. 1203 Circle/Edge Guide, 1205 Offset Base, 1206 SignCrafter, 1212 SignPro, 1207 Design/Inlay Kit)

A note about TurnLock™ Guide Bushings:

• Your TurnLock™ Guide Bushings are injection molded parts and designed for a “snug fit”.

• Upon first use, you may find the fit to be somewhat tight.

If this is the case: work the bushing back and forth in the base to “seat” and “work fit” the bushing.

1, 5, 14 4

2, 7

1, 7

2, 3, 8, 15

2, 3, 7

9, 13

1, 10, 15

2, 3, 9, 10, 12, 15

4, 6, 8