Owner`s manual

OM-263 001 Page 36
7-3. Emptying Particle Bin
! Disconnect and lockout/tagout
input power. Follow established
procedures regarding the instal-
lation and removal of lockout/
tagout devices.
! Do not operate unit without filter
or with dirty (plugged) filter.
! Clean or replace filter when dirty
(plugged).
! Allow cooling period before in-
specting or replacing filter, or
cleaning particle tray and spark
guard.
! Do not breathe the particles col-
lected by the fume extractor. Wear
approved safety equipment (res-
pirator, gloves, long sleeve shirt)
when servicing filter and spark
guard. Dispose of used element
and collected particles according
to local, state, and federal re-
quirements.
! Turn off compressed air supply
and bleed air lines before servi-
cing fume extractor. Bleed mani-
fold air pressure to 0 psi (0 kPa).
! If ANY air is injected into the skin
or body seek medical help imme-
diately.
! Read and understand the Material
Safety Data Sheets (MSDSs) and
the manufacturer’s instructions
for metals, consumables, coat-
ings, cleaners, and degreasers.
! Wear protective equipment when
disconnecting compressed air
supply. Internal air tank is under
pressure and will discharge when
air supply is disconnected.
! Use lifting aid or two persons to
remove particle tray. Particle tray
is heavy when full.
1 Particle Bin
2 Clamps
The 22 gal. (83 L) particle bin is standard
on all models.
Unlatch clamps to lower the bin.
Roll bin away from fume extractor.
Empty bin.
Reinstall bin and secure with clamps.
Tools Needed:
2
1
254231-B