Instruction for Assembly

7. Connect a sidewall (14) to collected design above, between
themselves, having clamped eccentrics
(V-01) (picture 5).
8. Attach a socle (11) to
sidewalls (13, 14) according to a
headdress of Ø3 mm by means of
screws of Ø3x16mm (E-01) (picture 3).
9. Attach a cover (18) to
sidewalls (13, 14) and a partition (16)
then clamp eccentrics (V-01) (picture
5).
10. Check squareness of a
framework on diagonal according to the
picture 6.
! Diagonals of a framework of a
dresser have to be equal.
11. Put back walls (1) a white
surface down and beat on product
perimeter by means of nails of Ø2x20
mm (F-01) and nails (F-01) through a
washer paper clip (K-01) on partition
(16), to sidewalls (13, 14) and a cover
(18) having receded from each edge of
25 mm (a step between nails of 150-170
mm).
12. To the low revetted end faces
of right and left wall (13, 14) at distance
of 20-50 mm from back and forward
edges of a detail beat thrust bearings
with a nail (G-01) according to the
picture 7.
13. In openings of Ø5mm in sidewalls (13, 14) insert shelfholders
(I-01).
14. Install shelves (17) on shelfholders (I-01).
15. Fix overlays of loops (L-02/1) on a sidewall (14) according to a
headdress of Ø3mm by means of screws of Ø4x16mm (E-02) (picture 8).
! Separate loops (L-02) on a slip and
the case (L-02/1 and L-02/2
respectively) having turned off the
screw connecting them and having
removed a slip.
16. Fix cases of loops (L-02/2) to
a door (12) by means of screws of
Ø4x16mm (E-02) according to the
picture 9.
! If necessary regulate a fit
of door (12) and gaps between
them, at the end fix the position of
loops by screws (picture 10, 11,
12).
17. Fix the shock-absorber (S-02)
to a partition (16) by means of screws of
Ø4x16mm (E-02).
G-01
20-50 мм
R-02/ 1
1
2
!1=2
picture
5
picture
6
picture
7
picture
9
Е-02
L-01(02)/ 1
picture
10