Instruction manual

R
Pellerin Milnor CorporationPellerin Milnor Corporation
P. O. Box 400, Kenner, LA 70063-0400
Litho in U.S.A.
Find the correct assembly first, then find the needed components. The item letters (A, B, C, etc.) assigned to
assemblies are referred to in the "Used In" column to identify which components belong to an assembly. The item
numbers (1, 2, 3, etc.) assigned to components relate the parts list to the illustration.
Parts List—Hold Down Adjustments
Hold Down Adjustments
60" & 72" Rapid Load and Staph-Guard
BMP701672R/71051
(Sheet 1 of 1)
.
The shipping bolt (Item 9) must be removed from all four hold downs before the machine is operated and
before making any adjustment. The four base pads of the machine must be adjusted so that the machine
touches all four pads simultaneously with uniform pressure.
This holds the machine steady during washing and allows the machine to travel vertically without “twist”
or undulating motion.
Place the machine on a level floor. Lower the shell front and back onto three blocks. Locate two blocks
in front and one block in the rear. The blocks must hold the machine shell about 3/8" above the base
pads.
Remove the four bolts holding the ring weldment (Item 5). Place the ring weldment firmly on top of the
plug welded onto the base pad and measure the clearance between the mounting bracket and the ring
weldment (Item 5). Stack the necessary number of shims to remove all of the measured clearance. Place
extra shims on top of the mounting bracket so that they may be used for later adjustments if necessary.
Check the adjustment by turning the master switch (located on the MILTROL) on and observing how the
machine seats itself on the pads, and how it rises vertically off of the pads. No rocking motion as the
machine goes down, or twisting motion as it rises should be present. Repeat the adjustments if necessary.
Enough clearance must exist between the ring weldment (Item 5) and the plug on the base pad when the
machine goes into extraction to prevent binding, but must not be so much that it prevents the machine
from being pushed down solidly while the machine is in wash and drain. When the machine is empty it
should move 2" from the down-solid to the free-hanging position.
.
1. Plate, Hold Down Centering 03-06215B
2. Shim, Hold Down Ring, 0.25" 03-06216A
3. Shim, Hold Down Ring, 0.12" 03-06216B
4. Shim, Hold Down Ring, 0.06" 03-06216C
5. Ring Weldment W3-06215
6. Hex Nut, 5/8"-11 UNC2 15G238
7. Lockwasher, 5/8", Medium 15U315
8. Hex Tap Screw, 5/8"-11X4", Full Thread 15D125
9. Hex Cap Screw, 1"-8X4-1/2", Grade 5 15K300
PARTS LIST
ITEM DESCRIPTION PART NO
125