Instruction manual

5. With the shell pushed down, attempt to pull each test shim out from between the bracket and rubber pad. The
test shims should all be tight. If any shim(s) are not pinched tightly between the bracket and pad, take note
of which one(s) are not.
Make final adjustments as follows:
6. Set the Master switch to off, remove the test shims and make the necessary changes to the shims below the
rubber pads as indicated by the above test.
7. Repeat Steps 3 through 6 as required, until this test is successful.
8. Once the adjustments are completed, secure all shims and rubber rest pads with the adhesive provided.
Ë60" Divided Cylinder Machines
These machines have push-down stops on the four corners of the frame which appear as shown in FIGURES
5 and 6. When pushed down, the ring weldments (which move with the shell) must seat firmly onto the plugs which
are mounted atop the base pads. The push-down travel dimension must assure that 1) the ring weldments and plugs
are far enough apart when the shell is not pushed down, so as not to interfere with the free movement of the shell,
and 2) that all four stops are in solid contact when the shell is pushed down. To accomplish this, proceed as follows:
1. With the Master switch set to off and the shell hanging free, remove the bolts securing the ring weldments to
the mounting brackets. Set each ring weldment on top of its respective plug, removing any shims which
may have been used and placing them next to the ring weldment.
2. Measure the gap between the top of the ring weldment and the bottom of the mounting bracket, at each loca-
tion.
3. Stack shims on top of the ring weldment as required to make each gap exactly 2 inches as shown in FIGURE
5. If the gap at any location is less than 2 inches without shims, the shell must then be raised in the frame,
using the procedures previously described.
4. Once the proper arrangement of shims is made, remount the ring weldment and shims to the mounting bracket
(see FIGURE 6). Any extra shims may be stacked on the top side of the mounting bracket plate to which the
ring weldment is attached.
Mounting Bracket
Shell
(hanging
free)
Frame
Shims
Ring
Weldment
2"
ÎFIGURE 5 (MSSM0302AE)
ÎShimming Ring Weldments
Shell
(hanging
free)
Shims
Ring
Weldment
ÎFIGURE 6 (MSSM0302AE)
ÎReconnecting Ring Weldments
131