Instruction manual

ÏDaily and Weekly Maintenance Items

Frequency Component Action

Daily Hydraulic Tilt System

(48", 52", and 72" Tilt machines)

• Reservoir

FIGURE 1 and NOTE 1

Check fluid with

machine not tilted

Hydro-Cushions

(all machines)

FIGURES 2 and 3

Check for leaks

Weekly Final stage and other v-belts

(throughout all machines)

FIGURES 1 and 12

NOTES 2 and 3

Check for wear and

tension

NOTE 1: Tank should be approximately three-quarters full when the machine is not tilted. Do not over-fill.

NOTE 2: V-belt instructions for the first week of operation

• After 24 hours operation (three eight hour days), tighten final stage v-belts.

• After 80 hours operation (ten eight hour days), tighten final stage v-belts again.

• After 160 hours of operation (twenty eight hour days), tighten final stage

v-belts, and check all other v-belts and tighten if necessary.

NOTE 3: All v-belts are not alike. “Super” or “High Capacity” v-belts frequently have considerably higher

capacities than “Standard” belts. Sometimes, one brand of v-belt is more suitable than another

brand of v-belt, although both v-belts are “interchangable”. It is always best to purchase replacement

belts from the original manufacturer of the equipment. Purchasing exact replacements of the

original belts is the best way to assure belt life equal to the original set.

Occasionally, Milnor

will change a belt specification to improve belt life.

Belts purchased from Milnor

are as currently specified.

ÎFIGURE 1

(MSSM0201CE)

ÎHydraulic Fluid Reservoir Fill and Level Check Point

(located at rear of 48", 52", and 72" tilt machines only)

ÎFIGURE 2

(MSSM0201CE)

ÎTypical Hydro-Cushion

Maintenance Points

ÎFIGURE 3

(MSSM0201CE)

ÎTypical Upper Hydro-Cushion

Grease Fitting