Instruction manual

ÏMonthly Maintenance Items

Frequency Component Action

Monthly

(see NOTE 4 )

All Divided cylinder and Staph-Guard

main bearing and seals

FIGURES 4 through 10, NOTES 5 and 6

• Each bearing grease fitting

0.37 ounces (10.6 grams),

six strokes at two locations

• Each seal grease

fitting

0.12 ounces (3.54 grams),

two strokes at two locations

NOTE 4: Once a month or once every 200 operating hours, whichever occurs first.

NOTE 5: Main bearings and jackshaft bearings (if so equipped) are prepacked with

lubricant at the factory. Do not add grease for thirty days. During the first

month’s operation, some grease will ooze out of the automatic grease fittings

at the bottom of the housing(s). This is normal. These grease fittings allow

excess grease to escape, thus avoiding over-heating. This escaping lubricant

need not be replaced. Every time these bearings are lubricated, the surplus

grease will come out of the spring loaded relief fittings after a few hours

running time.

NOTE 6: Bearings can run hot enough to make it extremely uncomfortable for a

person to hold his hand on the bearing housing for more than a few seconds.

This is normal.

ÎFIGURE 4

(MSSM0201CE)

Î42" Divided Cylinder Front

Bearing and Seal Grease Fittings

ÎFIGURE 5

(MSSM0201CE)

Î42" Staph-Guard

Front and

Rear Bearing and Seal Grease

ÎFIGURE 6

(MSSM0201CE)

Î42" Divided Cylinder Rear Bearing

and Seal Grease Fittings

ÎFIGURE 7

(MSSM0201CE)

Î60" and 72" Divided Cylinder Front

Seal and Bearing Grease Fittings

ÎFIGURE 8

(MSSM0201CE)

Î60" and 72" Divided Cylinder Rear Seal and Bearing