Instruction manual

ÎFIGURE 9
(MSSM0201CE)
Î60044 and 72044 Staph-Guard
®
Front Bearing and Seal Grease Fit-
ÎFIGURE 10
(MSSM0201CE)
Î60044 and 72044 Staph-Guard
®
Rear
Bearing and Seal Grease Fittings (lo-
ÎFIGURE 11
(MSSM0201CE)
ÎAll Open-Pocket Machine Seal and
Bearing
Grease Fitting Plate
ÎFIGURE 12
(MSSM0201CE)
ÎTypical Drive Train Components (48" machine shown)
ÏMonthly Maintenance Items
Frequency Component Action
Monthly
(see NOTE 4)
42" Open pocket main bearings and seals
FIGURE 11, NOTES 5 and 6
• Front and rear bearing grease fitting
0.12 ounces (3.54 grams), two strokes at two locations
• Seal grease fitting
0.06 ounces (1.77 grams), one stroke at one location
48" Open pocket main bearings, seals and Hydro-Cushions
®
FIGURES 11 and 13, NOTES 4, 5, 6 and 7
• Front and rear bearing grease fitting
0.31 ounces (8.85 grams), five strokes at two locations
• Seal grease fitting
See “Semi- AnnualMaintenance Items” in this section
• Hydro-Cushion
®
bypass
(48" open-pocket only)
Drain small quantity of oil. If milky, see note 7 below
52" and 72" Open pocket main bearings and seals
FIGURE 11, NOTES 4, 5, and 6
• Front bearing grease fitting
0.62 ounces (17.7 grams), ten strokes at one location
• Rear bearing grease fitting
0.31 ounces (8.8 grams), five strokes at one location
• Seal grease fitting
0.19 ounces (5.31 grams), three strokes at one location
Drive train components
FIGURE 12
• Pulleys and clutches
Check for wear
• All components
Remove soil build-up
NOTE 7:“Milky” oil is contaminated by water. Drain cylinder and unscrew cap on
bottom of bypass (See BMP890047). Remove piston rod and inspect the upper piston cups and lower piston for wear or damage. Worn piston cups allow water from the air supply to enter hydrocushion. Repair worn parts and change oil.
Hydro-cushion bypass
ÎFIGURE 13
(MSSM0201CE)
ÎHydrocushion Bypass Valve
(48" machines only")
28