Instruction manual

ÏQuarterly Maintenance Items
Frequency Component Action
Quarterly Brake Components
• Disk brake reservoir (60" and 72" Staph-Guard
®
only)
FIGURE 21
Check level, refill as required (Always use fresh fluid from a sealed container)
• Brake band grease fittings (60044 and 72044 WP2/WP3 only)
FIGURE 22
0.06 ounces (1.77 grams), one stroke at two locations. Do not allow grease to drip on brake surfaces.
• Brake shoes
FIGURE 23
Check for wear, adjust or replace as required.
• Disc brake pads
(60" and 72" Staph-Guard
®
only)
FIGURE 24
Check for wear, replace as required
Hydro-Cushions
®
FIGURES 2 and 3
Check oil level, add as necessary Inspect washer, replace as necessary
Motors
FIGURE 12 NOTES 8 and 9
See “BALDOR MOTOR MAINTENANCE...,” MSSM0274AE in this manual.
Hydraulic tilt pressure gauge
FIGURE 25
Check pressure while machine is returning from a tilted position
• 42" Open pocket
800 PSI (55 Bar)
• 48" Open pocket
900 PSI (62 Bar)
• 72" Open pocket
1000 PSI (69 Bar)
Door seal pressure regulator
FIGURE 26
Check settings with machine in bare manual and clockwise wash rotation. See instructions for operating individual outputs in the reference manual.
• 42" and 48" Open pocket
48 - 50 PSI (3.37 - 3.51Kg/cm
2
)
• 60" and 72" Rapid load
25 - 28 PSI (1.76 - 1.97 Kg/cm
2
)
• 60" and 72" Staph-Guard
®
18 - 20 PSI (1.27 - 1.41 Kg/cm
2
)
NOTE 8: If motor manufacturer’s instructions conflict with manual section, follow nameplate instructions.
motors are warrantied by their manufacturers, not by Milnor
®
.
NOTE 9: Pump grease slowly with relief ports open. Do not over-lubricate.
32