Instruction manual

ÏSemi-Annual Maintenance Items
Frequency Component Action
Semi-Annual Main bearings and seals
• 48" Seal grease fittings
FIGURE 11
0.12 ounces (3.54 grams), two strokes at one location
Gear reducer
FIGURE 27
Check oil level, refill as required
Push Back and Forward System
FIGURE 28 and NOTE 10
• Down position pressure
gauge and regulator
Check pressure in a “wash step” 3 - 5 PSI (.21- 0.35 Kg/cm
2
)
• Tilt position pressure regulator
and gauge
Check pressure in a “wash step” 30 PSI (2.11Kg/cm
2
)
Push-down control valves (72" Rapid load and Staph- Guard
®
)
FIGURE 29 and NOTE 11
Observe operation and adjust if required
Recirculation (48" dye models only)
FIGURE 30
Replace hose
ÏAnnual or Less Frequent Maintenance Items
Frequency Component Action
Annual Gear reducer
FIGURE 27
Change oil and clean magnetic plug (if so equipped)
Hydro-Cushions
®
FIGURE 2
Change oil
Every 2 years
Hydraulic system
FIGURE 28
Change oil
NOTE 10:52" and 72" machines are not equipped with a tilt pressure regulator
or gauge.
NOTE 11:Adjust push-down control valves so that machine moves down evenly,
and all push-down sockets meet simultaneously. If the back of the machine comes down first, close the valve slowly. If the front comes down first, open the valve.
ÎFIGURE 27
(MSSM0201CE)
ÎTypical Gear Reducer Fill and Drain
ÎFIGURE 28
(MSSM0201CE)
ÎPush Back and Forward Hydraulic System
Gauges and Regulators
(42", 48", and 72" Tilt Models)
ÎFIGURE 29
(MSSM0201CE)
ÎPush-Down Control Valve
(72" Rapid load and Staph-Guard
®
only)
ÎFIGURE 30
(MSSM0201CE)
ÎShell Door Recirculation Hose
(48" dye machine only - cover removed for clarity)
33