Instruction manual

ÊApplying Threadlocker

NOTE: The following threadlocker information and

illustrations are excerpts from the Loctite

User’s

Guide and are used with permission.

For maximum strength, threadlocker must fill the thread

voids completely, as shown in FIGURE 2. Organic or petro-

leum solvent will remove excess uncured adhesive from

joints. Consult information below for the specific fastener ap-

plication.

ËBolts and Nuts

—See FIGURE 3.

1. Clean all threads (bolt and nut) with cleaning solvent.

2. Spray all threads with Loctite

Primer N. Allow to dry.

3. Insert bolt into through hole assembly.

4. Apply several drops of threadlocker onto bolt engage-

ment area.

5. Assemble and tighten nut to correct torque for the

threadlocker.

ËBlind Holes

—See FIGURE 4.

1. Clean all threads (bolt and nut) with cleaning solvent.

2. Spray all threads with Loctite

Primer N. Allow to dry.

3. Squirt several drops down female threads into bottom of

hole.

4. Apply several drops to bolt.

5. Tighten to correct torque for the threadlocker.

ÎFIGURE 2

(MSSM0101CE)

ÎCorrect Threadlocker Use

Apply here

Not here

ÎFIGURE 3

(MSSM0101CE)

ÎApplying Threadlocker to

Through Hole

Onto

threads

Onto

threads

ÎFIGURE 4

(MSSM0101CE)

ÎApplying Threadlocker to Blind Holes

MSSM0101CE/9906AV (2 of 19)