Service Parts List

2776-20 (Non-Remote)

M18™ FORCELOGIC™ 3" Underground Cable Cutter

Oct. 2019

54-00-2776

REVISED BULLETIN

SERVICE PARTS LIST

BULLETIN NO.

WIRING INSTRUCTION

DATE

CAT. NO.

SPECIFY CATALOG NO. AND SERIAL NO. WHEN ORDERING PARTS

SERIAL

NUMBER

Drwg. 2

H49A

Due to the combination of hydraulics and electronics in this tool,

service can only be performed at Milwaukee Authorized Hydraulic Repair Centers:

MILWAUKEE TOOL Central Repair

1401 Sycamore Avenue

Greenwood, MS 38930-7277

Please send your tool directly to this location for service.

Via e-Service at: www.milwaukeetool.com/e-service

questions, please call 1.800.SAWDUST (1.800.729.3878)

Visit www.milwaukeetool.com to nd your closest

Milwaukee authorized Hydraulic repair center

Return it to a MILWAUKEE factory Service Center location, freight prepaid and insured.

A copy of the proof of purchase should be included with the return product.

If you have questions please contact Milwaukee Product Service at:

Product Technical Support via phone at: 262.783.8642

Via email at: METProductSupport @milwaukeetool.com

Disassembly is not recommended and could void the warranty.

2776R-20 (Wireless Remote)

CAT. NO.

SERIAL

NUMBER

H50A

LUBRICATION INSTRUCTIONS PAGE 3

CUTTER HEAD SERVICE PARTS PAGE 2

ACCESSORIES PAGE 2

TORQUE SPECIFICATIONS PAGE 4

PAGE 1
BULLETIN NO. SERVICE PARTS LIST 54-00-2776 SPECIFY CATALOG NO. AND SERIAL NO. WHEN ORDERING PARTS REVISED BULLETIN M18™ FORCELOGIC™ 3" Underground Cable Cutter CAT. NO. 2776-20 (Non-Remote) CAT. NO. 2776R-20 (Wireless Remote) SERIAL NUMBER SERIAL NUMBER H49A DATE Oct.
PAGE 2
Accessories and External Service Parts for 2776-20 & 2776R-20 3" Underground Cable Cutters 1a(2x) 1c 1b 1c 82 1a 1d 1h 1n 1b(2x) 1d NOTE: Correct placement of pins (1j) and retaining rings (1n) are important for the proper functioning of the cutter head assembly. Install as illustrated with retaining rings on flat side of blade.
PAGE 3
LUBRICATION INSTRUCTIONS S2 Grease, No. 49-08-5267 243 Blue Loctite® Thread Sealant, 44-22-0095 NOTE Regarding parts to receive thread locking sealant: Place one to two drops of the recommended Loctite thread locking sealent (or the equivelant) to the threads of parts shown prior to installation. ® NOTE Regarding parts to be lubricated: Apply a light coating of grease to all highlighted parts shown prior to installation. Reference the key above for grease types.
PAGE 4
TORQUE SPECIFICATIONS 1a(2x) 1c 1b 1c 82 1a 1d 1h 1n 1b(2x) 1d NOTE: Correct placement of pins (1j) and retaining rings (1n) are important for the proper functioning of the cutter head assembly. Install as illustrated with retaining rings on flat side of blade.