Instruction manual

Adaptto E-drives Lab. 2013
4.1) Quick menu buttons setup
---------------------
| Buttons Mapping 1/2|
| Quick menu: |
|> Button UP TRK |
| Button Left Light |
| Button Right Cruise|
| |
| Traction Control |
| |
| Throttle buttons 2/2|
|> Button A Charge|
| Button B Light |
| Button C Cruise|
| Button D Horn |
| |
|Charge enable\disable|
| |
---------------------
Charge
Regen-Charging mode enable\disable
Cruise
Throttle Cruise enable\disable
Backwd
Reverse on\off
TSC
Traction control
LCD Br
Display brightness LOW\HIGH
2WD
2nd controller enable\disable
LS en
LS mode enable\disable
DCDC
DCDC mode on\off
Horn
Horn ON
Light
Low Beam Light on\off
HiBeam
Hi Beam Light on\off
Strobe
Strobe mode ON
StrHrn
Strobe with Horn ON
(5) BMS Setup
---------------------
| BMS SETUP 1/2|
|>BMS enable NO |
Max-BMS enable\disable
|>BMS SETUP |5.1)
Only when using MAX-BMS
| Battery AH 10.2AH |
Battery capacity AH
| Battery WH 00350Wh|
Battery capacity WH
| 2/2|
| Dischg cutoff 026V |
Low Voltage Discharge cutoff
| |
---------------------
4.Info and error messages
!THR! show when more than 4.5v appear at the throttle input.
!BMS! show when bms enabled but not connected\misconfigured
LowBat means your battery voltage is lower than set in BMS section
!HALLS! means hall sensors are not connected\not workable
Cruise shows when cruise control is active
brake will show up while regen-braking.
Charge will show up when regen-charging mode enabled (by pressing “up” while charging
you will go to Charge monitor)
Protect means than over-current protection is on.
10