Instruction manual

Adaptto E-drives Lab. 2013
3.5)
---------------------
| Advanced setup 1/5|
|>Angle corr. -4.99°|
Static Angle correction (halls position in current motor)
| Timing +034uS|
Static time correction (firmware version related)
| Ind timing 0628uS|
Set for minimum power consumption at 75% PWM no load
| PWR timing +0.53 |
Set for maximum torque at high power levels
| 2/5|
|>OVS timing 007° |
0-7 value allows you to run a bit faster on the same voltage
|>Termosensor YES |
Motor T° sensor Disable\Enable\Enable with prediction.
| TSensor type KTY84 |
Motor T° sensor type
| T° limit 180°C |
Motor T° limit
| 3/5|
|>Hall Offset 300° |
Hall Angle offset
| Hall Reverse NO |
Hall reverse
| Wire Reverse YES |
Phase wires revers
| Wire R, mOhm 100 |
Phase wires resistance
| 4/5|
| ControlMethod SLESS |
Sin-wave(AUTO)\Square-wave\Sensorless square-wave
| SIN5X 0000 | 5
Harmonic compensation
| SIN7X 0000 | 7
Harmonic compensation
| SIN11X 0000 | 11
Harmonic compensation
| 5/5|
|>System Reset |
Full system reset to factory defaults
| |
---------------------
3.6)
---------------------
| DCDC setup 1/1|
|>Current limit 9.62A|
Set Current limit (will hiccup when overcurrent detected)
| Voltage out 6.29V|
Output voltage
| DCDC Enable NO |
Enable\Disable DCDC mode
| |
---------------------
DCDC mode is a special feature that allows you to use your controller as a
power supply with given voltage. You can set voltage and current limit you want
to get, than enable DCDC mode.
It is required to use charging inductor and capacitors at the output.
(4) Interface Setup
---------------------
| Interface SETUP 1/2|
|>Speed Units KPH |
Speed unuts (toggles between metric and imperial)
| t° display OVH |
t° bar on main screen show t° or overheat current limit
| LCD refresh 0.2S |
LCD refresh speed
| Brightness HI |
LCD Brightness HI/LOW
| 2/2|
| BackLight off |
Enables back-light (only when dc-dc connected)
| HeadLight str |
Enables headlight (only when dc-dc connected)
| Quick menu NO |
Enables\disables Quick menu
| Buttons map |4.1)
| |
---------------------
9