Installation Guide

ELECTRICAL CONNECTIONS

WARNING: To avoid possible electrical shock be sure electricity is

turned off at the main fuse or breaker box before wiring.

NOTE: The Aire Control

System is equipped with a learning frequency

function which has 256 code combinations to prevent potential

interference from other remote units. The frequency on your Receiver

and Transmitter units have been preset at the factory. (Fig. 2) No

frequency change is necessary, should you desire to install another fan

within the same home or area with a separate frequency code please see

the "frequency interference" troubleshooting section of this instruction

manual to learn how to change the frequency.

Caution! The dip switches on the receiving unit are covered with a

rubber cover, remove the rubber cover and then have it replaced after

making any changes to the dip switches.

Step 1 Connect the fan supply (black) wire to the black household supply

wire as shown in Figure 3 & 4.

Step 2. Connect the neutral fan (white) wire to the white neutral

household wire.

Step 3 Connect the fan ground wire (green) to the household ground

wire.

Step 4. After all splices are made, check to make sure there are no loose

strands. As an additional precaution we suggest to secure the plastic wire

connectors to the wires with electrical tape.