Installation Guide

Fig. 17

CAUTION: Before starting installation, make sure power is turned off at the circuit breaker.

ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 75 watt limiting

device. If lamping exceeds 75 watts, the ceiling fan's light kit will shut off automatically.

If you do not plan to install the light kit with your fan at this time, skip step 1, 2 & 3.

1. Remove 1 of 3 screws from the mounting plate and loosen the other 2 screws. (Do not remove)

2. While holding the LED light kit under the fan motor assembly, make the 2-pin wire connections: -

- White to white - Black to black

3. Place the key holes in the LED light kit over the two mounting screws previously loosened from the

mounting plate. Turn the LED light kit until the LED light kit locks in place at the narrow section of the

key holes. Secure by tightening the two screws previously loosened and the one previously removed.

(Fig. 17)

4. Raise the glass shade (or metal light cover) up against the mounting plate and secure it to the fan by

turning the glass shade clockwise until snug. DO NOT OVERTIGHTEN. (Fig. 17)

NOTE: The metal light cover included with your fan is an option to replace the glass for the light in the

event that you prefer not to use the light feature of your fan. The metal light cover is not necessary for the

light operation; it can be saved for later use if desired.

INSTALLING THE LED LIGHT KIT & GLASS SHADE

GLASS

SHADE

SCREWS

MOUNTING

PLATE

LED LIGHT KIT