Specification

6
Fig 6
THE FOLLOWING OPERATION MUST BE ACCOMPLISHED BEFORE INSTALLING THE GLASS SHADE.
Step 1. Insert the blades into the motor housing blade slots, push blade until it stops. You should be
able to hear the inside safety pin drop into the blade hole to secure the blade in place. (Fig. 6)
CAUTION: Re-check each blade to make sure all blades are secured to the motor by holding the blade
from the tip and gently pulling it outwards. The blades should be snug to the motor housing
without any up, down or sideways play.
All blade sets are grouped by weight. Because plastic injection varies in density, the fan may wobble
even though the blades are weight matched.
BLADE REMOVAL
In the event that the blades need to be removed, use the blade removal tool included with your fan.
Remove the blades by pulling the safety pin via the opening above the blade in the motor housing
as shown. (Fig. 7)
BLADE INSTALLATION