Manual design and all elements of manual design are protected by U.S. Federal and/or State Law, including Patent, Trademark and for Copyright laws.
.n.. The Minka-Aire® warranty is for one {1 year from the date of purchase from an authorized Minks Aire® dealer. fiefdom ' fan {excluding wall controls and electrical components), to the original purchaser or user. * The warranty is voided with the use of any non devices, Eq., wall controls or electrical dimmer switches, eto* The warranty is void once the original purchaser or user ceases to own the fan or the fan Is moved from its original point of installation.
Warranty Service information To obtain warranty service during the warranty period, the purchaser should rectum the fan with the sales receipt tithe original place of purchase. The authorized Minka-Aire® dealer, at its sols discretion, will either repair or replace the fan after verifying the legitimacy of the warranty claim. Replacement is subject to availability of the same model. If the model is unavailable it will be replaced by one of equal value.
CONTENTS ol FINISHING THE INSTALLATION e 7 PACKAGE CONTENTS... o d OPERATING THE REMOTE CONTROL/WALL CONTROL .. . B INSTALLING THE FAN. .3 CARE OF YOUR FAN .2 BLADE INSTALLATION. 4 TROUBLESHOOTING. 10 HANGING THE FAN., .5 SPECIFICATIONS . .11 ELECTRICAL .
1 SAFETY RULES 1. Before you begin installing the fan, shut power off the circuit breaker of the fuse box. 2. Be cautious] Read all instructions and safety information before installing your new fan. Review accompanying assembly diagrams. 3. Make sure that all electrical connections comply with local codes, ordinance, or National Electrical Codes. Hire a qualified electrician or consult a do-it-your self wiring handbook if you are unfamiliar with installing electrical wiring. 4.
NOTE: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions and situations that may occur. it must be understood that common sense,caution and care are factors which can not be built into this product. These factors must be applied by the person{s] installing, caring for and aerating the unit. NOTE: READ AND SAVE ALL INSTRUCTIONS! R e TO REDUCE THE RISK OF FIRE. ELECTRIC SHOCK OR OTHER PERCH! JURY.
2 PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: 1. Fan blades{3} A Mounting hardware: 2. Hanger bracket Wire donuts) 3. Canopy #8%3/4 Machine screws (2} 4. Canopy cover #10x1. 5 Wood screws {2} 5. Standard down rod assembly (67} 4mm Star washers {2} Minimum-length Metal washers (2} 6. Coupling cover Lock washers {2} 7. Fan motor/housing assembly B. Blade attachment hardware: 8. Receiver with 6 wire nuts 1/4 %15 . 8mm screws with lock 9.
INSTALLING THE FAN Tools Required: Philips screw driver, slotted screw driver. step-ladder, wire cutters, electrical tape. s MOUNTING OPTIONS if there isn't an existing mounting box, then read the following instructions. Disconnect the power by removing fuses or turning off circuit breakers. Secure the outlet box directly to the building structure. Use appropriate fasteners and building materials. The outset box and its support must be albs to fully support the moving \ weight of the fan {at least 50 Ibs ).
4 BLADE INSTALLATION Align the 3 holes from the blade to the fan motor. Secure blade with 3 blade screws with locked washer provided. Follow the same process for the remaining two blades. (Fig. 5} Fan moor N All blade sets are grouped together by weight. Because plastic materials vary in density, the fan may wobble even though the blades are weight matched.
WARNING: All of the parts, hardware and components such as the hanger bracket and hanger ball have been provided for your safety and the proper installation of your new ceiling fan. The use of other parts, hardware or components not supplied by Minks Therewith the fan will void the Minks Aire® Warranty. REMEMBER to turn off the power. Follow the steps below to hang your fan properly: Step recurred the hanger bracket to the ceiling outlet box using screws and washers included with mounting hardware (Fig.
WARNING: To avoid possible electrical shock be sure electricity is turned off at the main fuse or breaker box before wiring. NOTE: The Ire Control® System is equipped with a learning frequency function which has 256 code combinations to prevent potential interference from other remote units The frequency on your Receiver and Transmitter units have been preset at the factory. (Fig.
Step 3.Receiver to House Supply Wires Electrical connections: Connect . the WHITE wire{Neutral) from the outlet box to the WHITE wire / y marked AC in N” from the receiver. Connect the BLACK wire{Hot) from the outlet box to the BLACK wire marked "AC in L” from the receiver. Secure all wire connections with the plastic wire nuts 14} Step 4.1f your outlet box has a GROUND wire (Green or Bare Copper) connect this wire to the Hanger Ball and Hanger Bracket Ground wires.
7 FINISHING THE INSTALLATION Step 1. Tuck connections neatly into ceiling outlet box. Step. Remove one screw from the hanger bracket and lesson the other screw around 174", Step 3. Align the canopy up to ceiling and over the loose screw. Place the canopy into key hole and rotate canopy clockwise. (Figure 15} Step 4. Secure the canopy by use previous removed screw. Step S Place the canopy cover to the canopy and rotate canopy cover clockwise rocked into right position.
OPERATING THE REMOTE CONTROL/WALL CONTROL Remote Control only: Install a A23 volt battery (included). To proven damage to transmitter remove the battery if not used for long periods of time, instructions apply to ceiling fans that feature 2 DOWN D. OFF-ON Slide Button (Wall Control Fans Only) t { & button) only or g fans that feature an UP This button tums the power OFf and On to the Fan and flfi..
Speed settings for warm or cool weather depend on factors such as the room size. Ceiling height, number of fans, ete. The Reverse switch is located on the coupling.
9 CARE OF YOUR FAN Here are some suggestions to help maintain your fan. 1.Because of the fan’'s natural movement some connections may become loose. Check the support connections, brackets and blade attachment twice a year. Make sure they are secure (it is not necessary to remove fan from the ceiling). 2 Clean your fan periodically to help maintain its new appearance over the years. Use only a soft brush or lint free cloth to avoid scratching the finish.
SYMPTOM Fan will not start SOLUTION » Check to make sure the wall switch is turned on. # Circulate fuses or breakers, « Caution! Make sure the power is turned off before performing the following steps. « Remove canopy and check wire connections. ® Check wall control transmitter connections{if applicable. & Note:fan must be installed at 2 maximum distance of 40 feet from the transmitting unit for proper signal transmission between the transmitting unit and the fan’s receiving unit.
SYMPTOM Fan Wobble SOLUTION » NOTE:All blade sets are grouped by weight. Because wood and plastic blades vary in density. the fan may wobble even though blades are matched. # Make sure outlet box is secured to building structure, if necessary use the wood screws provided to further secure outlet box to joist. # Make sure hanger bracket is secure ko the outlet box, screws are tight. # If a Balancing kit is provided follow the instructions included with the balancing kit to help correct any excessive wobble.
SYMPTOM Frequency Interference SOLUTION 1.Turn the power off to your ceiling fan. 2 Please use a small size tool to change the frequency settings on the control system. 3 Return power io the unit Hereafter the AC power is on, do not press any other button on the transmitter before pressing the "Stop” button.doing so cause the procedure to fall. 4. Within 60 seconds of muting the fan's AL power ON. Press the transmitter's "Stop” button and hold the "Stop,” bunion for 10 seconds. 5.
11 SPECIFICATIONS These are typical readings. Your actual fan may vary. | Fan Size Speed Volts Amps Watts RPM COM NW. GCW. CF They do not include amps and wattage used by the light {s). ” Low 120 0227 14 61 2699 oo Lo, 52 Medium 120 o386 34107 4537 o go. 2448 For any additional information about your High 120 0.554 66.4 153 6580 Minks Ire’ Ceiling fan, please write W.M.Wm .E.P.m\w 1151 W. Bradford Court.